|
06-22-2011, 12:22 PM
|
#1
|
2 Rivet Member
1984 34.5' Airstream 345
Sacramento
, California
Join Date: Jun 2011
Posts: 27
|
Air compressor
While someone was looking at water pump, he noticed that one of the electrical lines to the air compressor was not attached. He reattached it.
I looked at my dash control and there is no air pressure. MH has been stored for the winter and someone told me when bought and inspected there was a slow leak to one of the bags. Should I first try putting in air via port which seems to be inside the rear storage compartment?
I did have key engaged as per manual. I've reset breakers. What to do? Help appreciated as always... trying to get on the road!
|
|
|
06-22-2011, 02:26 PM
|
#2
|
3 Rivet Member
Join Date: Sep 2010
Posts: 159
|
Is the compressor running at all? If so it will take much longer than you might think to build pressure. The factory compressor does not have a high output at all.
|
|
|
06-22-2011, 04:44 PM
|
#3
|
Rivet Master
Currently Looking...
1984 31' Airstream310
Ajo
, Arizona
Join Date: Mar 2007
Posts: 7,649
|
There is an in-line fuse (somewhere) for the compressor, besides the main fuse. The question is, what blew the fuse?
|
|
|
06-22-2011, 05:17 PM
|
#4
|
2 Rivet Member
1984 34.5' Airstream 345
Sacramento
, California
Join Date: Jun 2011
Posts: 27
|
The compressor looks fairly new; I'm guessing it was replaced. When I turn on the engine I do hear a noise back there (it's under the bed, so helpful), anyway... As I said, it sat all winter and if there was a slow leak, I'm guessing the bags would be empty.
Is the solution to go to a tire air pump and try to get it to the valve in the outside compartment?
It's also possible the gauge on the dash is not working; it's not where it is "supposed to be" re: owner's manual and there are a bunch of wires hanging down beneath.
If I drive without air suspension I'm guessing it's a bad thing as I already have new tag axle et al and replacing it was expensive.
????
|
|
|
06-22-2011, 05:18 PM
|
#5
|
2 Rivet Member
1984 34.5' Airstream 345
Sacramento
, California
Join Date: Jun 2011
Posts: 27
|
Oh, and I'm in one of those places where the word RV scares the **** out of all the mechanics.
|
|
|
06-22-2011, 06:14 PM
|
#6
|
Rivet Master
Currently Looking...
1984 31' Airstream310
Ajo
, Arizona
Join Date: Mar 2007
Posts: 7,649
|
Quote:
Originally Posted by silverdream2
Oh, and I'm in one of those places where the word RV scares the **** out of all the mechanics.
|
Tire pump is not going to get it. Go to your local tire store and get 90 psi in it. I've seen other 345s with a external air fill, and like our compressor (which is the second) wondered about the crappy under-sized compressors/ poor design AS used. Vinnie put a pretty cool compressor in the Tin Crumpet, which I believe went to 125 psi, which is what those bags need (no offense Lily), maybe he'll climb in.
|
|
|
06-22-2011, 09:01 PM
|
#7
|
3 Rivet Member
1986 34.5' Airstream 345
Key West
, Florida
Join Date: Jun 2010
Posts: 168
|
The water pump is next to the compressor and has a 30amp breaker. You can jump it from there to see if your compressor is working and pump up your bags to get the rig somewhere it can get fixed.
One more thing if you try this disconnect the wire going to the key (at the Compressor not at the key) as it will backfeed the accessories and you will have all sorts of problems. The water pump is fed by the house and the compressor is fed by the starting batt.
|
|
|
06-22-2011, 09:12 PM
|
#8
|
Rivet Master
1982 28' Airstream 280
Port Angeles
, Washington
Join Date: Aug 2008
Posts: 1,943
|
The original compressors draw a lot of amps through the ignition switch, fuse block and long wire runs. The tank also collects water and needs to be drained frequently. Also check the check valve on the output side of the compressor. They can get stuck and cause trouble.
I installed one of these VIAIR Corporation - 450C IG Part No. 45050 45058. It's a nicely built unit and I like the 100% duty cycle at 100 psi. I installed a relay near the batteries with a 10 gauge wire to the compressor. I operate the relay from the original wire from the dash. Gets lots of amps to the compressor with minimum load through the ignition circuit.
My 280 runs with about 72 psi. in the bags at normal ride height and load. I set the pressure switch to keep the tank at 100 psi. I figure this set up will out live me.
Cheers, Dan
|
|
|
06-22-2011, 09:37 PM
|
#9
|
Rivet Master
Currently Looking...
1984 31' Airstream310
Ajo
, Arizona
Join Date: Mar 2007
Posts: 7,649
|
Quote:
Originally Posted by Smartstream
Cheers, Dan
|
Thanks for the link, Dan. Now get moving on your trip and post lots of pics!
|
|
|
06-22-2011, 10:29 PM
|
#10
|
moderator
Commercial Member
2016 27' International
Currently Looking...
Wilton
, California
Join Date: Aug 2008
Posts: 1,711
|
Yup.. Dan, AirRowan and Mikeys advice is good. If you can find the air fitting on the accumulator tank you can manually fill the bags until they begin to lift the coach but dont exceed 75 lbs just in case. Then watch and see what happens. Maybe the air will leak out at one of the bags or an airline fitting. Should be pretty easy to determine. If it holds then maybe its time for a new pump. Good luck!
Vinnie
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|