I have noticed removed rivets that have still got a stub sticking up. Should this be there if the right #30 twist bit was used in removal?
Sometimes this can't be tapped inside, what to do about this?
What are the correct tools to use to pre-punch the rivet head?
I use an awl, but isn't there a self centering tool that is spring loaded? What is that called and what does it cost aprox.Where can it be bought?
Also when the rivet is the type with the well hole in the center after squuzing, is that hole open all the way thru, and thus necessitating filling it with pookey?
Rivet Link >>>> to see also:
http://www.airforums.com/forum...et+and+removal