When I was greasing my BAL stabilizer jacks I noticed the "interesting" caulking job around the driver's side rear jack of the tt.....this was done at the factory I am certain; they caulked around a 1/2" drain and ran the caulking around the jack turning rod. This pulled out the caulking. Great job of caulking--worse than mine
What is the drain from/to? Pretty close to the hot water heater.
Can I use Home Depot's best
inside/outstide caulking?
This caulking will not show. There are arrows pointing to jacking points--some square pieces -- are these pieces the actual place where you put the jack head?
Sorry about all the questions.