Has anyone had experience pulling dents out of A/S bumpers? There's no crease, so I'm assuming it might pull out OK. I was thinking of, with the bumper removed, slowly hammering at a piece of wood placed inside the bumper. Maybe starting at the edge of the dent. Any thoughts on this? - Roy
It should work
I had a woman in Oklahoma back into the aluminum bumper of my 2003 International, leaving a small dent from her bumper guard.
I took the bumper off and hammered ot out with an auto-body hammer on a padded board. The only reminder was a blemish in the polished finish which I could never quite match to the remainder of the bumper.
It took my largest screwdriver and a wrench on the shank to get the screws holding the bumper out.
|All times are GMT -6. The time now is 01:31 AM.|
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.