TG Twinkie

Hi- Did I see an older post about you fixing/ cleaning a KT lock? Do you still ? :-)

Hi,
You wouldn't happen to know of anyone who had an Argosy main door hinge for sale would you? They are different from the Airstream and mine snapped while trying to close the door.
Thanks
Carl

Thanks Doug! Ill see what kind of trouble I can avoid starting tomorrow, failing that, Ill email you where Im "stuck" if you dont mind?
Best regards,
Billy Chase

Thanks for the info TG! A lot of delays lately has me just about to start the work this weekend!
If you dont mind, can you go ahead and send me your email in case I run into some questions.

One question/concern I have is on the copper water lines running in/out of the heater tank.

Is it ok to assume its 1/2" Di? And that 1/2"sharkbites will work?
Best regards,
Billy J. Chase

Thanks TG! Im not the best with how pipes inner/outer DI are measured, will 3/4" sharkbite fittings and tubing work with the existing copper lines in/out of the water heater?
Thanks again!
Billy

Hi TG, you gave me advice on hot to run my homes how water line through the Airstreams hot water heater (thank you).
Is it possible to by pass the hot water heater all together? and connect my homes hot water line before it hits the hot water tank (so I dont have to keep its water hot) and have it then connect on exit water line from the water heater tanks?
Ive attached several images that may or may not help.
Any suggestions are welcomed!
Thanks,
Billy



https://www.dropbox.com/s/960tto0wps...tions.jpg?dl=0

Hello, probably a long shot, but do you have any more of those l-77 handles you made up a while back? Thanks

Hey TG,

I have a 26' 1974 Argosy also. I have been towing it with a 2001 F350. I just sold the truck and bought a 2016 Nissan NV3500. I am looking for a Weight Distribution Hitch. Are you still using the Andersen hitch and would you recommend it for my application?

Thanks

Peter

Hi - Noticed your photo with new cushions and I'm building a dinette and am looking for sources...
Thanks! - Steve

Hello from Olsburg, Kansas, I am currently working on a 76 24' Argosy. I am looking for a readable 12 volt wiring schematic. Previous owner/s ripped things out, threw things away, etc. Luckily, the bathroom in rear was intact. I have put in a new larger breaker box for 110 volts and now working on 12 volt system. I still have top/middle celing open and lower side panels are off. End caps are temporatily in place. I connected what I believe are all of the 12 volt wires to the Univolt that is working but humming like they do. It is putting out power when I checked it in my garage. I connected the battery to it and checked the twelve volt lines around the trailer and no power. I have yet to check the grounded frame connection to the Univolt. I did download some schematics for 76 AS but it I am unable to read the colors since the original photo is low pixel.