Univolt to Intellipower 9200 series

[Safari66]

I'm replacing my univolt with an intellipower 9200 in a1966 safari. I just got the intellipower in and have been looking at different methods of installation. My univolt had two sets of wires running to it, one bundle was red white and blue and the other was black and white. There were three fuses mounted on the unit. My intellipower has a male plug on it but I have no female receptacle on my trailer where the univolt was. I'm trying to figure out how to get this installed. Will I need to buy a fuse panel? Or is the pictured panel my fuse panel. And how do I plug this darn thing in?



Panel my battery hooks up to



Fuses on old univolt



This is where the white wire ends up



Where univolt was

[Alumaholic]

Your Intellipower requires four connections:
1. You must ground it
2. You must pug it into a properly intalled, standard 120VAC receptacle*
3. You must connect the positive 12 volt DC battery lead
4. You must connect the negative 12 volt DC battery lead

If this doesn't make sense, please get someone to assist you.
Please ensure that your Airstream is not plugged in to shore power and
Disconnect your battery terminals before installing your converter
* Ensure the 120 VAC receptacle is properly installed with correct polarity!