I bought a used onan model 4.0 BF-3CR16000B. It started right up in the old RV. Now it will blow fuse F2, I replace the fuse and it starts, runs my 13amp saw just fine.I shut it off and then it won't start because F2 is blown.
Can anyone help with this?
Thanks
Dave
Thanks for the reply but that's not it.This is on the floor in my shop not hooked to anything. The F2 fuse is built into the control panel with the start-stop switch.This is a fuse not a circuit breaker. Also this thing is at least 10 years old.Probably closer to 20 years
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.