Then I went to the underbelly access panels....
Found a habitat....from previous place of state...and during some chewed wires. So, I replaced/repaired the damaged wires to the convervter box:
Attachment 133295
Attachment 133296
This was from a panel on the street-side...I dropped all the access panels(popped those rivets); and a curbside panel the had been replaced at somepoint--behind wheel well section (had some screws in it).....
Yep, A LOT of cleaning, thorns, the STENCH
....
Bleach and ammonia water--wonderful!!
YES, for the time being I Utilized GE Aluminum Silicone for ALL of the Access points and Screws(mainly Stainless)....
So...Similar Situation in the wheel well area(side-to-side)....the rivets were 'popped' and I went looking
.....
No suprise: MORE CLEANING!!!! I ended up pulling ALL the insulation from these 2 sections.
NO I don't have pics--the duty was bad enough
!!!
I DO have these 2 sections of the underbelly to replace insulation and get buttoned up(in the wheel well area)....
I decided to venture back inside
....