1969 31' Sovereign
1975 25' Tradewind
Walnut Creek
, California
Join Date: Nov 2010
Posts: 153
Before I remove bath end cap
I've got a dent in an upper rear end panel. I've already popped one out in a lower panel by pushing from the inside. This dent is up under the bath end cap. Before I remove that end cap I am hoping someone has a great idea for pulling that dent from outside.
Try painless dent removal companies. They use a suction cup device and pull out the dent from the outside. Is it possible to get access without fully removing the end cap? Maybe just release the lower edge of the end cap, flex it out of the way and reach up in to the dent.
1969 31' Sovereign
1975 25' Tradewind
Walnut Creek
, California
Join Date: Nov 2010
Posts: 153
Quote:
Originally Posted by wasagachris
Try painless dent removal companies. They use a suction cup device and pull out the dent from the outside. Is it possible to get access without fully removing the end cap? Maybe just release the lower edge of the end cap, flex it out of the way and reach up in to the dent.
I'm gonna try that. I've got a 3 inch crack in the cap right where I need to pull it out. I'm afraid pulling on it will worsen that crack and make my decision for me about the 11 panels.
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.