|
During my remodeling I took a few progress pics. Here is the slide shell with most of the decorative (mouse fur) and cabinetry layers removed. I did not attempt to remove the edging around the shell which is riveted to the shell itself. That would have to be removed to allow the slide to travel further out to access the rollers. Under the carpeting and pad you will find 3/4" plywood which spans that area.
You will note that there is a power junction mounted against the forward end of the slide shell which feeds the outlet under the table. The electrical schematic for my trailer did NOT have this junction point in the wiring leg identified. I did have one of those cap twisted connections loosen which caused my outlet to lose power and it was puzzling to track down. The power runs back to another junction point found at the leading edge of the street-side wheel well under where the microwave is located in the 30' & 34' models (just forward of the refrigerator for 28' models).
__________________
"Good judgement comes from experience. Experience comes from bad judgement."
Sir Tristan
Air #48582, S/SO #003, WBCCI #4584
|
Linear Mode
