Univolt is out
The original unit came out very easily, just two screws in the floor on the opposite side of the battery box. Since it mounted right next to the battery box there were no screws holding it down or had vibrated out.
I have a new Powermax Boondocker 55 amp unit ready to go after I make a run for some new 8 AWG cooper wire to connect to the fuse panel. My glass fuse panel looks good so I'm going to keep it.
The only connections to be made are the pos and neg ones that just require the 8awg wire that runs just a foot in length to the same connections on the fuse panel.
Hardest part was lifting it out while laying on my side and reaching all the way to the wall where it was located.i thought everyone was kidding when they referred to it as a boat anchor....no joke
Hopefully the rest goes just as easy.
|