Images in Category: Member's Photos
|
Drilled the Honda gas cap to accept the valve stem. Used a O-ring on each
|
Description |
Drilled the Honda gas cap to accept the valve stem. Used a O-ring on each side in order to get an air tight seal. |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 221
|
|
Drilled a hole in the bottom of the gas cap and inserted a 4" piece of
|
Description |
Drilled a hole in the bottom of the gas cap and inserted a 4" piece of steel brake line that would extend down into the Honda tank. |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 225
|
|
Used a plastic container the first time. Later, the outboard fuel can
|
Description |
Used a plastic container the first time. Later, the outboard fuel can |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 200
|
|
Close up view of the valve stem mounted in the Honda gas cap
|
Description |
Used O-rings on each side to seal the valve stem. |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 265
|
|
Honda and fuel can with fuel filter connected
|
Description |
Honda and fuel can connected. You can see the small fuel filter on the edge of the fuel can. Filter highly recommended. Learned that the hard way. |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 259
|
|
Outboard fuel can and EU2000 (Note the fuel filter)
|
Description |
Inline fuel filter is hard to see on the edge of the can. Highly recommended. Learned that the hard way. |
User |
Raptorrider2001 |
Category |
Member's Photos |
Dimensions |
360 x 225
|
|
|
|
|
Display Options |
Showing Images 1 to 9 of 14 |
|
Disclaimer:
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.
All times are GMT -6. The time now is 08:07 AM.