Images in Category: 58Overlander
|
|
Adding Brace To Template To Locate Tank Fitting
|
Description |
|
User |
57Vintage |
Dimensions |
851 x 479
|
|
|
Sub-floor Joints
|
Description |
I routered a slot in the ends of each panel and inserted a 1"X1/8" aluminum bar to keep the top of the sub-floor aligned for the finished floor. On the edges adjacent to the square tubing for the perimeter channel I used a 1/4" round over bit on the bottom of the sub-floor. This was to allow clearance of any welds between the perimeter tubing and the outriggers/frame rails. |
User |
57Vintage |
Dimensions |
1024 x 576
|
|
Receiver Welded To Rotisserie Cradle
|
Description |
|
User |
57Vintage |
Dimensions |
270 x 479
|
|
Trailer Ready For Shell Removal
|
Description |
|
User |
57Vintage |
Dimensions |
797 x 449
|
|
Locating Floor Holes To Access Tank Fittings
|
Description |
To locate the holes in the floor for tank fittings I used the floor templates I created and added additional braces with the correct hole diameter and location. |
User |
57Vintage |
Dimensions |
332 x 187
|
|
Drain Holes Into Belly Pan
|
Description |
Plastic tubing extends past bottom of perimeter frame (frame upside down on rotisserie) to keep water away from frame. |
User |
57Vintage |
Dimensions |
410 x 231
|
|
Drain In Channel
|
Description |
I drilled holes through the channel & perimeter frame & installed plastic pipe to allow water in the walls to drain into the belly pan. The vents in the belly pan allow the water to escape. |
User |
57Vintage |
Dimensions |
288 x 512
|
|
Display Options |
Showing Images 1 to 9 of 22 |
|
Disclaimer:
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.
All times are GMT -6. The time now is 06:27 AM.