stain2 Rivet Member
|
Last Activity: 10-07-2013 11:15 PM
About Me
- About stain
- City
- calgary
- State/Province
- Alberta
- Country
- CANADA
- Gender
- male
- Trailer #1
- 1959 26' Overlander
- Occupation
- carpenter
- About My Tow Vehicle
- gmc safari for now 1968 Olds Delmont later....
- Remove Page Peel in Upper Right Corner
- Remove the Page Peel from the upper right corner.
Blog
View stain's BlogRecent Entries
Latest Blog Entry
Posted 10-14-2009 at 03:34 PM by stain
Comments 0
Posted in Restoration Blogs
Well I have not done an entry in awhile !!! SO ... What is new !!! holiday In august so not much done that month ... I used 3/4plywood for my floor marine spar vanished and bolted down with elevator bolts..a little tricky to get the ply under the channel but I managed .. then I took off all the interior skins ... and pulled the remain insulation out of the walls and roof yuk...Clean the walls and roof and looked for water stains on the inside of panels... This helped me to find the leaks ... most...
Posted 10-14-2009 at 01:09 AM by stain
Comments 0
Posted in Restoration Blogs
I lost my camera in august so I have used my phone !! still looking for the camera.... I gotta get this posting pictures thing down !!!!
Posted 06-28-2009 at 12:31 AM by stain
Comments 1
Posted in Restoration Blogs
Today I got the center belly pan drop and the wheel wells out .. I am going to be able to reuse the front pan only as the back was badly patched up ,all of the sides will also have to be redone due to the outriggers poking through .. no more walking on iron I was beginning to feel like an iron worker ... drilled out some rivets today... The wells will have to be touched up... .. stain...
Posted 06-25-2009 at 11:53 PM by stain
Comments 1
Posted in Restoration Blogs
Well I found my camera today.. so I have a few pictures to post... I have taken off all the lower skins so I had to wired her back up today and now I have lights again.. I have been to busy at work to get much done this week ...
Posted 06-23-2009 at 06:23 AM by stain
Comments 1
Posted in Restoration Blogs
Well I should be installing the sheeting for the floor this week.. I have done two coats of spar varnish and will be apply the third coat after they are installed...I will be using 3/4 inch plywood on top of bubble foil insulation..I will be leaving the back sheet off for any plumbing that needs to be installed. after removing all the delaminated plywood the trailer smells a lot better ...I have also removed the bottom row of panels and insulation.. I am going to restore her as close to vintage...
Recent Comments