Bowmans

We have been busy lately with work but found some time this weekend to work on more of the cabinets inside. In between working, I cut and put together the floating panel separation walls for the fridge side of the hall. This weekend, they were sanded and 4 of the 5 installed along with the shelving.



This is a picture of the walls in place. It took a while to get the backside...

We sealed the shower walls with a PVC textured shower board from a box store and 100% silicone sealer. Here are a couple of shots before the hall wall went on:




We put a coat of polyurethane on the walls before mounting them, then put 2 more coats while in place. Here are...

We finished the painting sometime last week and put all of the ceiling lights, outlet covers, AC cover, wing window trim, end cap tambours, etc. back on. Below is some picts of the paint inside:

The front end:


The rear (bath plastics are in the way but...):

...

We needed to finish some stuff inside before we could paint the interior walls.

It started with the fridge. The frame of the fridge had some rust spots so we wire brushed these down to metal and put black appliance paint on the frame and doors. We will put pine panels back into the doors while we do the cabinets.

Before:


After:...

I had 5 days off in a row this week due to vacation, comp and furlough time (will be the same for the next 4 weeks). We are hoping to get a good bit done before winter hits.

First thing we did was replace the antennae with a Winegard Stellar III (I believe that was the name). The controller and cable fit perfectly in the holes for the old one and the base was the same size so only had to drill a few holes. We didn't have any corrosion under the old base but we did find alot of...