Rusted through hardware on step - source?

[caadoptees]

The hardware has rusted through on the right side of my step. It's on a '92 25' Excella. Anyone know any sources for the hardware? See photo.

Thanks.

Roger

[BobbyW]

Here is a list of the Authorized Airstream Dealers in California.

What does the other side look like? Is there anything special about these fasteners?

-BobbyWright

----------------- Legend ------------------
T = Classic Trailer
S = Safari Trailer
INT = International
XL = 355 Ford
L = Land Yacht Motorhome (Gas)
XC = Land Yacht Motorhome (Diesel)
XLD = 390 Land Yacht Motorhome (Diesel)
----------------------------------------------
C & G TLR SERVICE
9241 Sonrisa St.
Bellflower, CA. 90706
Telephone: 562-634-6286

Available At This Dealer: SERVICE CENTER
----------------------------------------------

INLAND RV CENTER INC.
391 Elizabeth Lane (Corner of 1700 Block, Railroad Street)
Corona, CA. 92880
Telephone: 800-877-7311

Available At This Dealer: PARTS
-----------------------------------------------
MANTECA TRAILER & CAMPERS
1990 E. Yosemite
Manteca, CA. 95336
Telephone: 209-239-1267

Available At This Dealer: T/S/INT
----------------------------------------------
RV’S OF SACRAMENTO
1051 El Camino Ave
Sacramento, CA. 95815
Telephone: 916-648-1314

Available At This Dealer: T/S/INT
----------------------------------------------
SKY RIVER RV
1960 Ramada Drive
Paso Robles, CA. 93446
Telephone: 805-226-9292

Available At This Dealer: T/S/INT/L/XL/XLD
----------------------------------------------
SOUTHWEST COACHES
6441 Burt Road (Lots 46, 47 & 27)
Irvine, CA. 92618
Telephone: 949-551-8597

Available At This Dealer: T/S/INT/L/XL/XLD
----------------------------------------------

SOUTHWEST COACHES
77-840 Varner Road
Palm Desert, CA. 92211
Telephone: 760-360-1880

[53flyingcloud]

caadoptee,
You might also check your owner's manual.
Good luck~~and, thanks for pointing this out as I have one on the same side rusty looking..
ciao

[83Excella]

Since the steps are AS unique a dealer would be a good bet. I looked at the vendor list on their site but nothing indicated for the steps.

John

[BobbyW]

All the Dealers I listed can order or supply parts.

-BobbyWright

[FrankR]

I may have missed the meaning of your post. The bolt or fastener must be gone or is broken. That bolt is just a flat head bolt with a sholderand recessed alen hex drive.. A stainless bolt with a bushing the correct size should make that repair better than factory. It doen't seem too tough a machine task. Got any more pics??

[caadoptees]

Here is a photo of the parts salvaged

[caadoptees]

View from the other side.