I am familiar with this issue. With my 2001 19' Bambi, it was possible to carefully locate the place on the inside wall opposite the badge, slice an "X" through the fabric with a box cutter where the bolts were located (about 1" cross), cut a small square flap of the inner skin approximately 3/4" across, bend that out, feel through the insulation for the nuts, and then remove them. I asked JC about the badge mounting stud locations so I could space the cuts properly, but I do not recall that size.
After remounting the badge, I bent the flaps back to their original position, covered the cut slots with metal air-duct tape, then pushed the interior fabric back over the hole. Because the fabric was self-adhesive, it stuck right into place and was not noticeable. That was six years ago and the fabric has held on without any noticeable cut.
__________________
Marshall Swartz
2001 19-ft Bambi
2013 Honda Ridgeline RTL
|