Need help, my Ambassador does not have a bypass on water heater. I can't figure out where the bypass can go, can't get good access to lines. Anybody have experience with this model? Otherwise I have to pump alot of pink stuff.
Thanks
Copper tubing! In a tight spot. You could make a temporary bypass for the water heater, undo the copper tubing flare nuts, IF you have enough room attach a 90° 1/2" mpt x 1/2" flare fitting to the flare nuts and a short 1/2" x 1/2" sink hook-up hose between, then the heater is out of the system. Compressed air does a good job of winterizing (watch the P.S.I.) blow-out plugs are cheap and if you do each appliance individually you can have enough force to push most of the water out....but nothing like a little antifreeze, don't forget the "p" traps and drain all the tanks.
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.