My door is sagging because the bushings are worn out and I need to get the pin out as well from the hinge to replace them. Did any of you ever happen to run across a site that had the inner bushings and new pin available?
Dan, your door may be differen't than the one on my 1965 overlander but mine was doing the same thing but it does not have bushings in the hinge. The hole was just drilled out and the hinge pin goes through. I had to weld the holes up and then re drill them so that they were true again.
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.