I was changing the light bulbs in the control center when the power wire from the stove fan touched the the panel. Now I don't have any interior lights and no power at the control panel when on shore power and the engine won't turn over. If I turn to accessories I have interior lights. I also have 110 when on shore power.
I can't seem to find a blown fuse and the inverter is still humming and I have 12 volt power at the fuse block after the inverter.
How can a tiny spark kill everything that was working fine before.
The schematic I have shows 2 wires from the control panel. One goes to the vehicle junction box and the other one to the solenoid on the 12 volt distribution panel . You might have messed up that solenoid because it is hooked to the engine battery.Not an expert just giving ideas.
The distribution panel on my 28' is under the passenger side chair .It has a drop down door that was under the carpet the solenoid is there.Doesn't show a color code in the book.
No the solenoid is round with 2 large posts and 2 small posts.I don't have any way to show you the schematic or a pic right now.If you search the forums there is info on where to find an owners manual.That would give you a better idea of what you are looking at.
I don't have a solenoid that I can find. I now have the engine running I had the neutral switch disconnected. I have 12 volt power with the key on acc and in the run position.
I don't have 12 volt when when connected to shore power.
I have a Magnetek 950-2-4 converter 50amp
Dose anyone know if there are any fuse-able links in these systems that could be the problem.
Can I test the converter to see if it is putting out 12 volts
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.