Quote:
Originally Posted by ericpeltier
JJA
Do you think there would have been any way to replace all the subfloor WITHOUT removing the c-channel? *crosses fingers*
Thanks!
|
Sorry but no. On my Streamline, the bellypan wraps up around the outside of the 'C' channel and is crimped and riveted through the channel. Also, the screws & bolts were rusted to brackets and channel. It was a real mess. I don't think it would have been possible on my streamline but I think airstreams are constructed differently and have seen where folks have figured out how..
I see from reading the forums that I'm not the only one. Thanks so much to everyone that has shared so much knowledge in this forum! & thanks to those who host and organize it. In the spirit of pay back/forward, here's the start of my blog. Worth noting that I never drilled a rivet before starting this project so think of it more as a how I did it rather than an expert how-to.
Linear Mode
