Restoring my Airstream...I need a section (4'5") of the 2" wide molding along bottom. Also need a 28" piece of the 1" molding over wheel well and one wheel well curve molding for left side of a fender.
Can anyone please help me?
I have tried Inland and all other sources I can find with no luck.
Nat finsness@comcast.net
1971 21' Globetrotter
Currently Looking...
Currently Looking...
Currently Looking...
Arvada
, Colorado
Join Date: May 2006
Posts: 3,530
Welcome to the Forums from another 71 GT owner.
All of the early 70's Airstreams use the same moldings. I needed a lower piece also and finally found someone local that was parting one out and obtained some from a donor trailer. Watch E-Bay and Craigslist and see if there are any RV salvage yards in your area. It may take some time but you will find it. I think I looked for close to a year before I found some.
I am doing a complete restore and reconfiguration on mine. See the link to my thread below.
This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.