1969 'C' Frame Channel is there a supplier

[Slowride66]

Howdy Y'all!

I am In th middle of a rear bath fix on my 1969 Land Yacht & I was wondering is there a supplier that make the stuff I need?

I was thinking of cutting a slice off & taking it to the local welding / fabrication shop & see if they can make it for me but before I do I was looking for any & all advice on what to do & what not to do.

I wanna get this floor back in before it gets cold.

Yes Virginia it get cold here in Florida maybe I won't be shoveling snow but is did sprinkle a bit of that white stuff last year.

Thank You all very much!

SR66

PS pictures & stuff so far


http://www.airforums.com/forums/f36/...out-78002.html

http://www.airforums.com/forums/f443...his-82279.html

[marzboy]

You are talking about the floor channel correct? If so you can make it yourself if you have a sheet metal break.

[Slowride66]

The Frame Rails.

I took a slice to the local welding place & they said it was 11 gage metal & it would be about $100,00 for Two 8' pieces . that is as long as their break is.


SR66

[marzboy]

Ok gotcha. I believe my 65 was 12 ga cold roll. I had to fabricate some to repair the rear section of my trailer.