Greetings chuckmac!
Quote:
Originally Posted by chuckmac
It has been three great weeks with my argosy and its working well but I do have a couple questions.
My jack seems to work great with the truck hooked up but will not work with the truck unhooked. is this routine or do I have a short?
|
I just went through a similar issue with the jack on my Overlander. In all probability, the electric jack was added to your coach as an aftermarket accessory as not that many under 30-foot Argosy trailers were equipped with the electric jack from the factory. Given this situation, it is hard to tell just how it may have been wired. On my Overlander (again, an aftermarket addition), it turned out that the jack had somehow been wired into the break-away switch wiring. Needless to say, the wiring was somewhat cobbled up and had sagged to the point where it caught in some weeds when entering a "primitive" campsite and pulled the connection just enough to create a periodic loss of power. A very helpful neighbor at this year's International Rally was a tremendous help and re-wired both my break-away switch and electic jack so that both are now properly wired. A separate power cable for the jack was run to the junction block for power and that elminated concerns about a recurrence.
Quote:
Originally Posted by chuckmac
The city water hookup simply is not there. My tank does not have one and again is this normal?
|
You have two separate issues here as the on-board demand system is separated from the city water system by a check-valve in your water pump -- or a check-valve in the incoming city water line. If your Argosy's water system hasn't been changed from stock,:
- The demand water system fills through a Bargman pull-out access door/funnel system. This small, lockable drawer is typically located on the front of the coach on the streetside almost behind the LP tanks about 30" from ground level. You potable water hose is just held in the funnel opening and the tank fills while the hose is manually held in the opening.
- The city water hookup should be at the rear of the coach. It is usually located on the streetside bumper support and should have a plastic plug in the hose connector.
Quote:
Originally Posted by chuckmac
Is there a set of plans available to convert the front hide a bed set up to a table and bench set up? I am definately going to switch over as we need a table.
|
While Argosy coaches did have a dinette as optional equipment, your coach should have a nice, three-leaf Credenza Table that folds out of a cabinet located on the wall beside your lounge. Another easy option would be to purchase an apartment sized drop-leaf table that could be used both as a dining table in the coach as well as for a dining table under the patio awning -- this is how the 1960s Vintage Airstreams were designed from the factory.
Quote:
Originally Posted by chuckmac
I also wonder if there is a set of plans to convert bunks to a double bed which then might entail a bathroom move.
|
The Argosy 24 was offered in both twin and double configurations. In the double configuration, there would be a dressing table/dresser setup on the curbside with a pull-out lounge on the streetside that makes up into an RV double bed.
Quote:
Originally Posted by chuckmac
Lastly is there a Argosy 24 that has a front dinette set up and a rear bedroom?
Might be better to sell mine and buy the other style. Done so much on my little unit that do not want to sell but will see.
|
The Argosy line pioneered the rear-door entry floorplans for Airstreams. The rear-entry Argosy 24 had a front bedroom with a center kitchen with "L" shaped dinette and rear bathroom. To me, this setup offers one of the better space utilization ideas for a 24' coach. The floorplan is illustrated in the scan from the sales brochure found below:
Good luck with your investigation/research!
Kevin