Pressure water tank filler - O ring - 1962 Bambi
I am trying to source a replacement "O" ring that fits inside the filler part (above the thread in the groove) that screws onto the neck of the pressure water tank.
I found some "O" rings that have the correct diameter but they are not thick enough to provide the proper seal. Mine is so worn out that it "looks" like it had a grove built into it. That may have been caused by the top of the neck that created that groove under pressure over the years. Does somebody know what this gasket should look like and where to find a replacement?
Thanks a lot.
Laurent
__________________
Laurent
1971 Overlander
1962 Bambi
1964 Sovereign
2003 G500
|