12 Volt Distribution Upgrade
Posted 10-03-2008 at 10:48 PM by nd48463
I finished the upgrade of the 12 volt system. Much cleaner, and all 12 volt works now!
Total Comments 6
Comments
|
|
wow-clean set-up ND! why do you have both old and blade type fuses?--I can appreciate your pic having just done a distribution rebuild on my 71 safari-Univolt out-zantrex 60amp in----thanx!--jim
|
Posted 10-12-2008 at 07:13 AM by jamesardis
|
|
|
The glass fuses are still there for the trailer towing lights. I could not find the blde style fuse holder locally so I picked up the glass holder at radio shack to get us by for the weekend trip. I also installed main (water tight)fuses right off of the battery in the battery compartment. Now that the season is over, it is time to begin floor repairs!
Nate |
Posted 10-16-2008 at 06:40 PM by nd48463
|
|
|
You must have exercised each circuit so let me ask you this? What is circuit 5, 6, 7, 8, and I think 9 which is listed in the manual? Don't have manual in front of me, so guessing on the numbers? I get it- the towing circuits.
|
Posted 10-20-2008 at 07:58 AM by ambassadorT
|
|
|
Circuits 5,6,7,8, 9 are the typical lighting and poser circuits. Circuits 10,11 are add on poser circuits for under cabinet, cupboard, and closet lighting. Each door his switched so when the door opens a light goes on inside the space. Really helps out.
|
Posted 10-26-2008 at 07:16 PM by nd48463
|
|
|
I've learned a lot and I've ordered some parts and replaced the old with new. But I have a question.
The fuse block with 9 positions has only 4 holes for the negative.(bought from best Rv if anybody cares). I have 8 wires. Can't double up because the holes are to small or the wires are to big. Any suggestions? |
Posted 11-10-2008 at 06:45 PM by ambassadorT
|
|
|
Your installation looks fantastic although I would suggest you wrap the wires at the holes in the skin or install rubber grommets so the wires don't fray with all of the bouncing around, they will surely wear through. Hopefully you'll be able to do this without too much trouble.
Brad FF |
Posted 11-20-2008 at 07:25 AM by flyfshr
|
Recent Blog Entries by nd48463
- Kitchen Galley removal (11-09-2008)
- Center bath removal. (11-01-2008)
- Rear floor repair begins. (10-26-2008)
- 12 Volt Distribution Upgrade (10-03-2008)
- Restoration Progress 1977 Excella 500 (10-02-2008)




