Rate this Entry

Door Dead Bolt Adjustment

Posted 04-01-2019 at 06:49 PM by AIRBULLDOGS

I'll give you the solution right away. Compress the rubber seal in front of it. You'll notice a little metal plate. Stick a screw driver between the door and that little plate and push it back out. Done.

The plate is a guide. It got mashed in because we were trying to close the door with the dead bolt engaged.

No need for a service repair call or being all upset at Airstream.

I had a problem with my door dead bolt not being adjusted properly. It wouldn't engage the hole. It was completely out of line. And it was all my fault!!
Attached Thumbnails
Click image for larger version

Name:	Snip20190401_3.png
Views:	99
Size:	570.3 KB
ID:	4910   Click image for larger version

Name:	Snip20190401_2.png
Views:	100
Size:	397.7 KB
ID:	4911  

Click image for larger version

Name:	Snip20190401_1.png
Views:	99
Size:	406.3 KB
ID:	4912  
Posted in Uncategorized
Views 87 Comments 1
« Prev     Main     Next »
Total Comments 1

Comments

  1. Old Comment
    stevejones's Avatar
    Interesting. Thanks for posting.

    The hand made AS door has lots of issues for sure.

    Steve
    Posted 04-07-2019 at 06:53 AM by stevejones stevejones is offline
 
Disclaimer:

This website is not affiliated with or endorsed by the Airstream, Inc. or any of its affiliates. Airstream is a registered trademark of Airstream Inc. All rights reserved. Airstream trademark used under license to Social Knowledge LLC.




Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 01:09 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.