Well today was kind of rainy and cold here in Michigan so I decided to plug in the portable heater and do some work on the floor. I pulled out all the supports for the washer/dryer then proceeded to the kitchen galley. In looking at the wheel wells, I decided they needed some attention. While I was investigating, I found about 5 or 6 tubes worth of silicone filling a gap in the outer wheel well ( about 1-1/2" x 1-1/2" x 18"!). To investigate further, I removed the galley kitchen....

nd48463

Today began the center bath removal. Water heater, toilet, sink, shower, walls, floor, etc have all been removed. i took my time to try and save as much as I could, since I do not have firm plans yet for the restoration. I also removed the Washer/Dryer combo which should remove a couple hundred pounds of weight. It is up for sale if anyone is interested. I also removed some more of the belly pan and curved side panels. I found an other skin over repair from what appears to be an incident with...

nd48463

Rear floor repair began today.... Belly pan, bumper, rear storage, and lower curved panels removed. Rear interior removed, and some lower interior panels. discovered a skin over skin repair on the roadside lower and am not sure what I am going to do yet.....


Progressing nicely!

nd48463

I finished the upgrade of the 12 volt system. Much cleaner, and all 12 volt works now!

nd48463

All cleaned up and ready to start!

Major projects for this winter include:

1. Floor replacement in bathroom, and rear bedroom.
2. Awning
3. New Tires
4. Dent in loser rear roadside
5. Electrical Distribution Upgrade
6. Axles

I will be reporting my progress here with before, after pictures.

nate

nd48463