| Bent door
If you put a 2x4 between the door and frame, you can use it as a pivot and push or pull on the door. This works well for normal production fits. 2" is a lot, it had to stretch the extrusion that makes the door frame. It will take a lot of work to get it bent back into shape. Don't push on the skin (maybe even pull the skins, they won't resist you trying to straighten it, and it will give you more options on places for leverage), work it slowly, aluminum responds better to slow and easy than one big hard push. It is going to take a suprising amount of force to bend it, there are a lot of angles in the extrusion. You will probably have to work it as 4 seperate corners, alternate around doing a little bit at a time.
There are studs in the hinges that are nutted inside the wall, but unless you have a bender this would be a lot easier to do on the trailer. It would be hard to clamp it well enough to hold the force you are going to need.
Good luck
John
|