[74Tradewind]

I put my Pergo type floor in myself. The hard part is cutting out around the cabinets and room dividers. One particular problem is this...1) To get the floor straight I layed one continuous strip right down the middle, stand at each end and align the strip until it looks straight then mark the floor all along the length. 2) Start putting the next row in on the side with the groove alternating the end seams. This way you can pull the whole thing out from the wall to install the pieces you have to cut and then put it back straight along the line you made. 3) If you do it this way you will make the final installation by attaching the new boards to the tongue side of the already installed piece. This is because it is easier to put the final pieces in attaching to the tongue.

There are some tight places and you might have to cut off the end tongue piece

Be sure to use the underlayment foam. I have a picture on this board somewhere.

Ciao, Brian