|
UPDATE:
I had the whole "system " apart today... hoping to stock up on some real T-bones at the market-
Here is the status:
1. The thermalocouple is in its proper place- it is located over a "J" shaped tube where I initially light the pilot.
2. On the top of this "J" tube is a small screen aprox 1/4" in dia.
3. The gas flow is reaching where I need to light; it is lighting...HOWEVER it has what I would call a "WILD" flame now. 1/2 blue 1/2 yellow.
Side Notes:
I did manage to clean out this "J" tube the best I could with a long screw and a bit of an old T shirt- I dug out what appeared to be a insect wing; along with some "mud" - not a lot but enough.
I can not seem to remove the "J" tube; as it is held in with 2 36year old screws- Now wanting to come out even with break away lube....
I remain frustrated but ...plugging along on this...I do believe it will work...just need to be able to get the little "box" where you light the flame apart to clean the pilot and "J" tube.
Forgive my ignorance here...is the Thermocouple the actual unit over the initial flame; or the unit that is attached by hard wire? if it needs replaced...is this a DIY or do I need a shop....( are there different sizes??)
Many thanks to all for the continued support and help-
Still in AZ...for now...
|