|
On our 60 trdwnd ,the panel was fine but the old sticky type of covering on the shower side needed replaced ,it was like that shelf lining sticky vinyl stuff
looked original as in one big sheet .I bought some of that white pebbly bath
covering at home depot .I measured the curved section needed and cut it out with a jig saw with a fine blade .I did a test fit then proceeded to sand
the edges to get the contour right .I used sheet plastic adhesive ,also at home depot and used a trowel to apply it so you have an even thin coat of
adhesive .I did have to remove the old shower diverter /faucet (replaced it)
Lastley ,it does not fit into the aluminum channel ,I cauked the edges all
the way around to seal it .The covering fits nicely flush with the channel and looks great.Basically the same thing markdoane has said to try and it works.
Scott
|