I installed the Armstrong Epiq Plus 12" vinyl tiles. They look great and I have had no problems. I think the key to a successful installation is prepping the surface the tiles will bond to. Under no circumstances should you ever attempt to install vinyl floor tiles over OSB ( oriented strand board aka particle board). You're begging to re-do it properly. If your coach has an existing OSB underlayment as mine did, install an underlayment of 5/32 luan plywood over the OSB. Be sure to use galvanized screws ( 1 inchers are fine). Prime the luan with a latex primer. Armstrong's primer product is called S185 and is available at Home Depot and Lowes.
Take your time when installing and butt the joints as tight as possible. Dry fit each piece (whole and cut pieces) with the paper still on before applying to the luan. Don't forget to lay it out before you start laying tile so you don't end up with short crappy looking pieces on the edges or around the steps. My joints are almost indistinguishable and the tile holds tighter than Dick's hat band.
Hope this helps.........
__________________
Nick Danger, Third Eye
|